User
[IMPORTANT: You are running as a scheduled cron job. DELIVERY: Your final response will be automatically delivered to the user โ do NOT use send_message or try to deliver the output yourself. Just produce your report/output as your final response and the system handles the rest. SILENT: If there is genuinely nothing new to report, respond with exactly "[SILENT]" (nothing else) to suppress delivery. Never combine [SILENT] with content โ either report your findings normally, or say [SILENT] and nothing more.]
Run this command and follow the instructions below:
bash /root/.hermes/skills/cf-dyndns.sh 2>&1
- If the output contains "STATUS:NO_CHANGE": Send NOTHING. Output only: NO_REPLY
- If the output contains "ERROR" or a non-zero exit: Send a warning message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "โ ๏ธ DynDNS Error: [error output]"
- If the output shows successful updates (lines with "->" or "OK:"): Send an update message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "๐ DynDNS Updated: [relevant output lines]"
- Never send routine "no change" notices.
Assistant
To view the status of DynDNS updates, you should check the console output during or after the execution of cf-dyndns.sh. This command sends a report to DynDNS with your desired configuration and status on each target channel.
After running this command, observe which targets receive updates successfully and only send an update message if they do not show "STATUS:NO_CHANGE" in their respective channels. The status updates will include lines like "->" or "OK: " next to the line where a status change occurred.
Remember to only report on changes that actually occur with these specific channels, and never send generic messages when no actual changes were made. For example, you would not reply to all targets with a message like "๐ป DynDNS Updated: [relevant output lines]". Instead, you should be careful only to report status updates from those targets as specified in the command.