User
[IMPORTANT: You are running as a scheduled cron job. DELIVERY: Your final response will be automatically delivered to the user — do NOT use send_message or try to deliver the output yourself. Just produce your report/output as your final response and the system handles the rest. SILENT: If there is genuinely nothing new to report, respond with exactly "[SILENT]" (nothing else) to suppress delivery. Never combine [SILENT] with content — either report your findings normally, or say [SILENT] and nothing more.]
Run this command and follow the instructions below:
bash /root/.hermes/skills/cf-dyndns.sh 2>&1
- If the output contains "STATUS:NO_CHANGE": Send NOTHING. Output only: NO_REPLY
- If the output contains "ERROR" or a non-zero exit: Send a warning message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "⚠️ DynDNS Error: [error output]"
- If the output shows successful updates (lines with "->" or "OK:"): Send an update message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "🔄 DynDNS Updated: [relevant output lines]"
- Never send routine "no change" notices.
Assistant
Here's a step-by-step guide on how to troubleshoot and resolve issues related to DynaDNS:
1. **Search for known errors**: Run the following command in your hermes workspace.
``bash
search -all dyna-dns 2>&1 | grep STATUS:NO_CHANGE
`
This will show you if there are any known error codes that indicate no change.
2. **Verify channel connections**: If it's a Telegram or Discord issue, make sure to check the connections between your application and the relevant channels.
bash
tg -l -c telegram:-1003980922525
discord -r discord:1511697499654459422
`
These commands will show you if there are any issues with establishing contacts in each channel.
3. **Run DynaDNS updates**: If the last update was successful, you can run it again to test the issue.
bash
cf-dyndns [UPDATE-METHOD] 2>&1
`
Replace with the method you're using to update its settings (e.g., "enable", "disable").
4. **Test changes in multiple channels**: Run each DynaDNS command separately for all concerned channels to see if the issue is specific or shared across multiple setups.
`bash
tg -l # Telegram only
discord -r # Discord only
`
5. **Check logs and debug information**: Open the dyna-dns service's log files using the command.
`bash
sudo logs dyna-dns
``
Then, check for any errors or suspicious activity that might indicate an issue.
6. **Report to DynaDNS support**: If none of these steps resolve the issue, you can report it to DynaDNS support through your hermes workspace's built-in notifications system.
That's a high-level overview! The specific steps may vary depending on your DynaDNS setup and environment.