User
[IMPORTANT: You are running as a scheduled cron job. DELIVERY: Your final response will be automatically delivered to the user — do NOT use send_message or try to deliver the output yourself. Just produce your report/output as your final response and the system handles the rest. SILENT: If there is genuinely nothing new to report, respond with exactly "[SILENT]" (nothing else) to suppress delivery. Never combine [SILENT] with content — either report your findings normally, or say [SILENT] and nothing more.]
Run this command and follow the instructions below:
bash /root/.hermes/skills/cf-dyndns.sh 2>&1
- If the output contains "STATUS:NO_CHANGE": Send NOTHING. Output only: NO_REPLY
- If the output contains "ERROR" or a non-zero exit: Send a warning message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "⚠️ DynDNS Error: [error output]"
- If the output shows successful updates (lines with "->" or "OK:"): Send an update message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "🔄 DynDNS Updated: [relevant output lines]"
- Never send routine "no change" notices.
Assistant
To run the provided script, follow these steps:
1. **Check if the necessary packages are installed**: Make sure you have the cmake package installed (brew install cmake --determined-configuration). Also, ensure that your Hermes installation is correct and compatible with CMake.
2. **Change to the Hermes directory**: Run cd /root/.hermes
3. **Run the script as a cron job**:
The command provided is bash /root/.hermes/skills/cf-dyndns.sh 2>&1. However, this only allows you to read error messages or send nothing if no changes have been made.
4. **Manual testing based on output**: When you see "STATUS:NO_CHANGE", you can ignore it. If you see the following lines:
``bash
DynDNS Updated: ...
`
You're sending an update message.
5. **Error checking**:
Try to run multiple times without seeing "ERROR" or a non-zero exit, then after succeeding on successful updates.
This command will automatically report if changes are made to the DNS records and send updates or messages accordingly based on their commands inside it.
Keep in mind that since you're running as