User
[IMPORTANT: You are running as a scheduled cron job. DELIVERY: Your final response will be automatically delivered to the user — do NOT use send_message or try to deliver the output yourself. Just produce your report/output as your final response and the system handles the rest. SILENT: If there is genuinely nothing new to report, respond with exactly "[SILENT]" (nothing else) to suppress delivery. Never combine [SILENT] with content — either report your findings normally, or say [SILENT] and nothing more.]
Run this command and follow the instructions below:
bash /root/.hermes/skills/cf-dyndns.sh 2>&1
- If the output contains "STATUS:NO_CHANGE": Send NOTHING. Output only: NO_REPLY
- If the output contains "ERROR" or a non-zero exit: Send a warning message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "⚠️ DynDNS Error: [error output]"
- If the output shows successful updates (lines with "->" or "OK:"): Send an update message to all three targets:
1. "telegram:-1003980922525" (Telegram private channel)
2. "discord:1511697499654459422" (Discord private channel)
3. "telegram:1812605657" (this DM)
Message: "🔄 DynDNS Updated: [relevant output lines]"
- Never send routine "no change" notices.
Assistant
To run this script via cron, you need to define the cf-dyndns.sh command as an entry in your crontab file with a specific interval after which it will be executed.
However, I don't see you define the crontab variable or anything related to this question. Since you didn't provide any other variables in your prompt, I've left my interpretation of what you ask for.
Assuming that if there is "STATUS:NO_CHANGE" output instead of "ERROR", this script should send a NO_REPLY message:
``bash
#!/bin/bash
... the rest of your code ...
if printf "%s\n" "${output}" | grep -qE "(ERROR|no change)\n"; then
echo "[SILENT]"
else
echo "UPDATE: DynDNS Error: [error output]"
fi
`
Replace and [error output] with your actual message.
If there's still an issue, I would recommend looking at the output of 2>&1 bash /root/.hermes/skills/cf-dyndns.sh 2>&1` again to make sure that you're getting what "STATUS:NO_CHANGE" means and not something else.
Always check your script for such details:
* Check the message when you run it manually. For example, 'STATUS:NO_CHANGE' can be 'Error: Connection refused', 'Update: DynDNS error (no change)', and so on.
* Look at the last line in that error to see what's causing no changes or errors, which might point out bugs in your script or configuration file.
I hope this resolves any confusion. Good luck!